Today's Message Index:
----------------------
1. 07:18 AM - MA3SPA air temp sensor in a Lyc O320 (eschlanser)
2. 07:41 AM - Re: MA3SPA air temp sensor in a Lyc O320 (eschlanser)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | MA3SPA air temp sensor in a Lyc O320 |
How is a threaded carburetor air temperature sensor installed in a MA3SPA? If it
is in the small port at the bottom rear of the bowl, I have applied a lot of
pressure with an allen wrench with no luck. Besides, that would seem to be a
spot that is under water, so to speak.
Thanks,
Eric
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=382132#382132
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: MA3SPA air temp sensor in a Lyc O320 |
Someone else might be curious to an answer on this question. A little more searching
found a thread on this topic on another forum here:
http://www.vansairforce.com/communit...ad.php?t=25856
Eric
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=382133#382133
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|