Today's Message Index:
----------------------
1. 01:51 PM - Re: MA3SPA air temp sensor in a Lyc O320 (FLYaDIVE)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: MA3SPA air temp sensor in a Lyc O320 |
Eric:
>From your description you are looking at the wrong end.
The threaded hole is located at the front of the Carb. It should unscrew
pretty easy with the proper size Allen Wrench or sometimes there is a
Square headed plug.
Use Anti-Seize when installing since you will have S/S against Aluminum.
Barry
On Thu, Aug 30, 2012 at 10:16 AM, eschlanser <eschlanser@yahoo.com> wrote:
> eschlanser@yahoo.com>
>
> How is a threaded carburetor air temperature sensor installed in a MA3SPA?
> If it is in the small port at the bottom rear of the bowl, I have applied a
> lot of pressure with an allen wrench with no luck. Besides, that would seem
> to be a spot that is under water, so to speak.
>
> Thanks,
> Eric
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=382132#382132
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|