---------------------------------------------------------- M14PEngines-List Digest Archive --- Total Messages Posted Wed 03/22/06: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 05:14 PM - Re: Installing V530 prop () 2. 05:28 PM - Re: Installing V530 prop (A. Dennis Savarese) ________________________________ Message 1 _____________________________________ Time: 05:14:01 PM PST US From: Subject: Re: M14PEngines-List: Installing V530 prop --> M14PEngines-List message posted by: > > From: "Scott Aldrich" > Date: 2006/03/13 Mon PM 06:58:28 PST > To: > Subject: M14PEngines-List: Installing V530 prop > > About to install the V530. When I take the lifting shackle off the engine > will it be obvious that the prop goes on the flange in a certain position? > If not, any particular position you are installing them? > > > > Thanks again, > > Scott >There is a dowel pin on the prop hub so it can only be installed in one position. Jim > > ________________________________ Message 2 _____________________________________ Time: 05:28:54 PM PST US From: "A. Dennis Savarese" Subject: Re: M14PEngines-List: Installing V530 prop --> M14PEngines-List message posted by: "A. Dennis Savarese" Yes, it will be obvious. There is a pin on the hub flange. It can only go on one way. Dennis ----- Original Message ----- From: Sent: Wednesday, March 22, 2006 7:12 PM Subject: Re: M14PEngines-List: Installing V530 prop > --> M14PEngines-List message posted by: > > >> >> From: "Scott Aldrich" >> Date: 2006/03/13 Mon PM 06:58:28 PST >> To: >> Subject: M14PEngines-List: Installing V530 prop >> >> About to install the V530. When I take the lifting shackle off the >> engine >> will it be obvious that the prop goes on the flange in a certain >> position? >> If not, any particular position you are installing them? >> >> >> >> Thanks again, >> >> Scott >>There is a dowel pin on the prop hub so it can only be installed in one >>position. Jim >> >> > > >