Today's Message Index:
----------------------
1. 02:39 PM - SV: Rocker arm & Valve clearance (=?iso-8859-1?Q?H=E5vard_N._Iversen?=)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Rocker arm & Valve clearance |
It is 0.3 med mer that is correct for both!
www.yaknorway.com
-----Opprinnelig melding-----
Fra: owner-m14pengines-list-server@matronics.com
[mailto:owner-m14pengines-list-server@matronics.com] P vegne av John
Nafziger
Sendt: 10. september 2007 22:54
Til: m14pengines-list matronics.com
Emne: M14PEngines-List: Rocker arm & Valve clearance
I went over the rocker arm & valve clearance per the maintance manual
(task card 247). It states a clearance of 0.3 mm for both valves,
cold.
The clearances on mine (romanian m14p) were mostly 0.3 mm for the
intake valves, but 0.45 mm for the exhaust valves. I set them all at
0.3 mm per the manual, but due to the consistancy of the exhaust
settings, I thought I'd ask if anyone has found a similar thing?
The placard on the nose case states 0.010", but I thought 0.012"
(0.3mm) close enough.
Thanks,
John
http://smallbusiness.yahoo.com/webhosting
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|