Today's Message Index:
----------------------
1. 08:15 AM - Advice Needed (michaelrorth)
2. 08:45 AM - Re: Murphy Moose-List: Advice Needed (George S. Coy)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
I have an M-462RF (very similar to an M-14) which will eventually be installed
in a Murphy Moose.
The time has come to have an engine mounting assembly fabricated using the mounting
ring that came with the engine.
How is the best way to remove the existing ring from the engine so that I can send
it out for fabricating the entire mounting assembly?
Looks to me like I need to remove at least one of the magnetos, the compressor,
fuel pump, generator, and carburetor.
How is the best way to ensure that these parts can be reinstalled with the proper
alignments and timing?
Thanks,
Michael
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=432410#432410
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | RE: Murphy Moose-List: Advice Needed |
Remove the mag caps and turn the engine until the fingers are pointed at the
timing mark. Remove the mags. DO NOT turn the engine after that. I don't
recall on a M462 if you have to remove the oil pump,. but you need to remove
the fuel pump and air compressor.
George
-----Original Message-----
From: owner-murphymoose-list-server@matronics.com
[mailto:owner-murphymoose-list-server@matronics.com] On Behalf Of
michaelrorth
Sent: Tuesday, October 28, 2014 11:15 AM
Subject: MurphyMoose-List: Advice Needed
--> <mosurf@xplornet.com>
I have an M-462RF (very similar to an M-14) which will eventually be
installed in a Murphy Moose.
The time has come to have an engine mounting assembly fabricated using the
mounting ring that came with the engine.
How is the best way to remove the existing ring from the engine so that I
can send it out for fabricating the entire mounting assembly?
Looks to me like I need to remove at least one of the magnetos, the
compressor, fuel pump, generator, and carburetor.
How is the best way to ensure that these parts can be reinstalled with the
proper alignments and timing?
Thanks,
Michael
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=432410#432410
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|