Today's Message Index:
----------------------
1. 12:39 AM - Re: need a NACA report (Clif Dawson)
2. 02:39 PM - showed my daughter my Piet today (w b evans)
3. 07:15 PM - Re: Rib profile question (Gnwac@cs.com)
4. 08:45 PM - Re: Rib profile question (javier cruz)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: need a NACA report |
--> Pietenpol-List message posted by: Clif Dawson <cdawson5854@shaw.ca>
Here's the NACA web site if you don't have it;
http://naca.larc.nasa.gov/
I took a quick look and didn't see it here though.
Clif
> Gentlemen,
>
> I am trying to locate on the WWW a copy of the following NACA report:
>
> Improved Baffle Designs for Air-Cooled Engine Cylinders
>
> by Silverstein and Kinghorn
>
> NACA WR-L-767 from August 1943
>
> Any help would be appreciatied.
>
> Chris Bobka
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
"Fishnet" <Fishnet@topica.com>
Subject: | showed my daughter my Piet today |
--> Pietenpol-List message posted by: "w b evans" <wbeevans@verizon.net>
My daughter came down from Conn. today and wanted to see the Piet. She hadn't
seen it since it was in the garage without wings, and I ran the engine for her.
Nice visit.
Poor guy has a Weedhopper at Newton airport, and from the high winds in the last
few days, it was over on it's back. Someone resecured the tail to keep it to
the ground as it layed. It's still a shame to see a plane in distress.
walt evans
NX140DL
FFP404
Piets and FFP's , shall they go on forever
do not archive
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Rib profile question |
--> Pietenpol-List message posted by: Gnwac@cs.com
Javier,
I'd like a copy of that email for the ribs. Can I be put on your list.
Thanks
Greg
Message 4
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Rib profile question |
--> Pietenpol-List message posted by: javier cruz <javcr@yahoo.com>
Hi Greg
here go the drawings..
Just check that this ribs will be correct for your
project, they use 1 inch spar, i use 3/4 so i
corrected them.. i send the draws for plot so i can
check the original, just a little difference..
Advice me if you have any problems for open the
draws..
good luck
Javier Cruz
__________________________________
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|