---------------------------------------------------------- Pietenpol-List Digest Archive --- Total Messages Posted Sat 11/15/03: 4 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 12:39 AM - Re: need a NACA report (Clif Dawson) 2. 02:39 PM - showed my daughter my Piet today (w b evans) 3. 07:15 PM - Re: Rib profile question (Gnwac@cs.com) 4. 08:45 PM - Re: Rib profile question (javier cruz) ________________________________ Message 1 _____________________________________ Time: 12:39:59 AM PST US From: Clif Dawson Subject: Re: Pietenpol-List: need a NACA report --> Pietenpol-List message posted by: Clif Dawson Here's the NACA web site if you don't have it; http://naca.larc.nasa.gov/ I took a quick look and didn't see it here though. Clif > Gentlemen, > > I am trying to locate on the WWW a copy of the following NACA report: > > Improved Baffle Designs for Air-Cooled Engine Cylinders > > by Silverstein and Kinghorn > > NACA WR-L-767 from August 1943 > > Any help would be appreciatied. > > Chris Bobka ________________________________ Message 2 _____________________________________ Time: 02:39:41 PM PST US From: "w b evans" "Fishnet" Subject: Pietenpol-List: showed my daughter my Piet today --> Pietenpol-List message posted by: "w b evans" My daughter came down from Conn. today and wanted to see the Piet. She hadn't seen it since it was in the garage without wings, and I ran the engine for her. Nice visit. Poor guy has a Weedhopper at Newton airport, and from the high winds in the last few days, it was over on it's back. Someone resecured the tail to keep it to the ground as it layed. It's still a shame to see a plane in distress. walt evans NX140DL FFP404 Piets and FFP's , shall they go on forever do not archive ________________________________ Message 3 _____________________________________ Time: 07:15:30 PM PST US From: Gnwac@cs.com Subject: Re: Pietenpol-List: Rib profile question --> Pietenpol-List message posted by: Gnwac@cs.com Javier, I'd like a copy of that email for the ribs. Can I be put on your list. Thanks Greg ________________________________ Message 4 _____________________________________ Time: 08:45:30 PM PST US From: javier cruz Subject: Re: Pietenpol-List: Rib profile question --> Pietenpol-List message posted by: javier cruz Hi Greg here go the drawings.. Just check that this ribs will be correct for your project, they use 1 inch spar, i use 3/4 so i corrected them.. i send the draws for plot so i can check the original, just a little difference.. Advice me if you have any problems for open the draws.. good luck Javier Cruz __________________________________