Today's Message Index:
----------------------
1. 07:09 AM - 4130 Question (At7000ft@aol.com)
2. 07:24 AM - Re: Pietenpol airfoil analysis (Ken Chambers)
3. 07:50 PM - Re: 4130 Question (dave rowe)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Tried to order some 22 gauge (.030) 4130 to make my rudder/elevator/aileron
horns today and can't find any (checked AS, Wicks and Shapio). Thinest I can
find is .040. Has anyone tried making these horns out of this thicker material?
Can anyone suggest alternatives? Bernie didn't use 4130 in the early days did
he?
They also said that normalized 4130 is impossible to find, and most is all
anealed. Does this make a difference to us Piet builders?
Rick Holland
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Pietenpol airfoil analysis |
--> Pietenpol-List message posted by: "Ken Chambers" <kchambers@winternals.com>
Oscar
Looks like there was some delay in getting the article on the
photoshare. My apologies.
I had a look a few minutes ago and it's there now.
Ken
-----Original Message-----
From: owner-pietenpol-list-server@matronics.com
[mailto:owner-pietenpol-list-server@matronics.com] On Behalf Of Oscar
Zuniga
Subject: Pietenpol-List: Pietenpol airfoil analysis
--> Pietenpol-List message posted by: "Oscar Zuniga"
<taildrags@hotmail.com>
>visit the Matronic's file share for a well-written and
>well-considered article with computer analysis by Mike Shuck
Been there... done that... no joy. Where's the article?
Oscar Zuniga
San Antonio, TX
mailto: taildrags@hotmail.com
website at http://www.flysquirrel.net
==
==
==
==
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: 4130 Question |
--> Pietenpol-List message posted by: dave rowe <rowed044@shaw.ca>
The plans I have say the hinges etc have been replaced by cast
aluminum. I designed and built bolt-together 6061 T-6 aluminum pieces
that far exceed the min strength required, and take a couple of evenings
to make out of flat and angle stock. Haven't done up proper set of
drawings, but have plenty of digital photos if you'd like.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|