Today's Message Index:
----------------------
1. 06:12 AM - Re: propeller for A65 (Carbarvo@aol.com)
2. 07:25 AM - aluminum parts (Les Schubert)
3. 07:56 AM - Re: propeller for A65 - TN Propellers (DJ Vegh)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: propeller for A65 |
If I needed a wooden propeller, I "wood" check with Tennessee Propellers.
Some time ago, I got an unbelievable deal from them on a custom made prop that
was not quite (but almost) as large as the one you're thinking about. Carl
Vought, Huntsville, AL
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
From: dave rowe <rowed044@shaw.ca>
Subject: Re: Pietenpol-List: 4130 Question
--> Pietenpol-List message posted by: dave rowe <rowed044@shaw.ca>
The plans I have say the hinges etc have been replaced by cast
aluminum. I designed and built bolt-together 6061 T-6 aluminum pieces
that far exceed the min strength required, and take a couple of evenings
to make out of flat and angle stock. Haven't done up proper set of
drawings, but have plenty of digital photos if you'd like.
Dave I would really like to se some pictures.
Thanks
Les
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: propeller for A65 - TN Propellers |
mine is a Tennessee Prop. Unbelievable quality. They use 1/16" laminations
where others use 1/2" or 3/8" I ended up with a 48 lamination prop (3" thick
at the hub). This makes for a very strong and stiff prop. They also give you
the option of a clear Urethane leading edge.
They will make any diameter, pitch or rotation you want in about 2 weeks... many
sizes are in stock.
Total cost was about $500 shipped.
www.tn-prop.com
DJ Vegh
N74DV
Mesa, AZ
www.imagedv.com/aircamper
-
----- Original Message -----
From: Carbarvo@aol.com
To: pietenpol-list@matronics.com
Sent: Tuesday, April 13, 2004 6:12 AM
Subject: Re: Pietenpol-List: propeller for A65
If I needed a wooden propeller, I "wood" check with Tennessee Propellers. Some
time ago, I got an unbelievable deal from them on a custom made prop that was
not quite (but almost) as large as the one you're thinking about. Carl Vought,
Huntsville, AL
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|