Today's Message Index:
----------------------
1. 12:48 AM - Re: Aircamper rudder control (Clif Dawson)
2. 07:52 AM - Re: Aircamper rudder control (Carl D. Vought)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Aircamper rudder control |
--> Pietenpol-List message posted by: Clif Dawson <CDAWSON5854@shaw.ca>
Just a suggestion, but I suppose string is going to be run to make
sure all the framework is going to be cleared?
My share of silly mistreaks I'd gladly trade for chocolate cake.
But then I'd never fit in the plane!
Clif
> --> Pietenpol-List message posted by: Michael D Cuy
<Michael.D.Cuy@grc.nasa.gov>
>
> Carl-- I used two nylon pullies under my seats and nylon/teflon fairleads
> on the
> fuse sides near where the cables exit the fuselage.
>
> Mike C.
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Aircamper rudder control |
--> Pietenpol-List message posted by: "Carl D. Vought" <carbarvo@knology.net>
First of all, thanks to those who responded to my email. Yep..I run a tight
string between the intended attachment points of the cable, just to check
out the clearances. In the case of the rudder cable, I had to run the
string (on the outside of the fuselage) between the rudder horn and a point
corresponding to the position of the lug on the rudder pedal. I have every
intention to be faithful to the original plans, but I'm dealing with an
abandoned project and the builder who preceeded me did a first class job of
installing pedals AND the front seat. I could have ripped out the front
seat to access the pedals to remove them and install a rudder bar, but I'm
unwilling to do that...Carl
On Thu, 21 Oct 2004 00:37:37 -0700, Clif Dawson <CDAWSON5854@shaw.ca>
wrote :
> --> Pietenpol-List message posted by: Clif Dawson <CDAWSON5854@shaw.ca>
>
> Just a suggestion, but I suppose string is going to be run to make
> sure all the framework is going to be cleared?
>
> My share of silly mistreaks I'd gladly trade for chocolate cake.
> But then I'd never fit in the plane!
>
> Clif
>
>
>
> > --> Pietenpol-List message posted by: Michael D Cuy
> <Michael.D.Cuy@grc.nasa.gov>
> >
> > Carl-- I used two nylon pullies under my seats and nylon/teflon
fairleads
> > on the
> > fuse sides near where the cables exit the fuselage.
> >
> > Mike C.
>
>
>
>
>
>
>
>
>
>
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|