----------------------------------------------------------
                           Pietenpol-List Digest Archive
                                      ---
                     Total Messages Posted Thu 10/21/04: 2
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 12:48 AM - Re: Aircamper rudder control  (Clif Dawson)
     2. 07:52 AM - Re: Aircamper rudder control  (Carl D. Vought)
 
 
 
________________________________  Message 1  _____________________________________


Time: 12:48:45 AM PST US
From: Clif Dawson <CDAWSON5854@shaw.ca>
Subject: Re: Pietenpol-List: Aircamper rudder control

--> Pietenpol-List message posted by: Clif Dawson <CDAWSON5854@shaw.ca>

Just a suggestion, but I suppose string is going to be run to make
sure all the framework is going to be cleared?

My share of silly mistreaks I'd gladly trade for chocolate cake.
But then I'd never fit in the plane!

Clif


> --> Pietenpol-List message posted by: Michael D Cuy
<Michael.D.Cuy@grc.nasa.gov>
>
> Carl-- I used two nylon pullies under my seats and nylon/teflon fairleads
> on the
> fuse sides near where the cables exit the fuselage.
>
> Mike C.


________________________________  Message 2  _____________________________________


Time: 07:52:45 AM PST US
From: "Carl D. Vought" <carbarvo@knology.net>
Subject: Re: Pietenpol-List: Aircamper rudder control

--> Pietenpol-List message posted by: "Carl D. Vought" <carbarvo@knology.net>

First of all, thanks to those who responded to my email. Yep..I run a tight 
string between the intended attachment points of the cable, just to check 
out the clearances. In the case of the rudder cable, I had to run the 
string (on the outside of the fuselage) between the rudder horn and a point 
corresponding to the position of the lug on the rudder pedal. I have every 
intention to be faithful to the original plans, but I'm dealing with an 
abandoned project and the builder who preceeded me did a first class job of 
installing pedals AND the front seat. I could have ripped out the front 
seat to access the pedals to remove them and install a rudder bar, but I'm 
unwilling to do that...Carl


On Thu, 21 Oct 2004 00:37:37 -0700, Clif Dawson <CDAWSON5854@shaw.ca> 
wrote :

> --> Pietenpol-List message posted by: Clif Dawson <CDAWSON5854@shaw.ca>
> 
> Just a suggestion, but I suppose string is going to be run to make
> sure all the framework is going to be cleared?
> 
> My share of silly mistreaks I'd gladly trade for chocolate cake.
> But then I'd never fit in the plane!
> 
> Clif
> 
> 
> 
> > --> Pietenpol-List message posted by: Michael D Cuy
> <Michael.D.Cuy@grc.nasa.gov>
> >
> > Carl-- I used two nylon pullies under my seats and nylon/teflon 
fairleads
> > on the
> > fuse sides near where the cables exit the fuselage.
> >
> > Mike C.
> 
> 
>  
>  
>  
>  
>  
>  
> 
> 
> 
> 
>