Today's Message Index:
----------------------
1. 06:53 PM - Re: Re: Engine Cowling Help (Michael Perez)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Engine Cowling Help |
I see your point Jack. A full sheet of poster board is quite flimsy and it
does not hold it's shape well. Using something as you mentioned would make
life a bit easier. I'll use what I have until I run out, (run out of the po
ster board or run out of patience) and then try some other materials.=0A-
=0AThanks you too Douwe, some good points to keep in mind while trying to f
igure this whole thing out.=0A-=0AAnother question for the list:- how m
uch space should I leave between the various engine pieces and the cowling.
I was thinking of about 5/16"+. I am not sure how much an A-65 will "roll"
around under the cowling.-=0A-=0A-=0A=0AIf God is your co-pilot...sw
itch seats.=0AMichael Perez=0APietenpol HINT Videos=0AKaretaker Aero=0Ahttp
://www.karetakeraero.com/
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|