---------------------------------------------------------- Pietenpol-List Digest Archive --- Total Messages Posted Sat 05/06/17: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 09:32 AM - Re: Vi Kapler hinges (taildrags) 2. 04:20 PM - Bolts for torque tube (Pocono John) ________________________________ Message 1 _____________________________________ Time: 09:32:16 AM PST US Subject: Pietenpol-List: Re: Vi Kapler hinges From: "taildrags" To those who asked about as-cast hinge blanks- yes, I will sell them in that condition. I will inspect the rough castings and sell them as-is, for the builder to turn into finished hinges. The operations required are not difficult or intricate, but they do require some care in order to have the pivot holes all turn out straight and square. I have jigs for these operations, but jigs are not essential if the builder is consistent about placing and aligning the holes. Smoothing and finishing are the most tedious operations, depending on the level of finish desired. I don't have anything like a mill and the parts don't require milling unless you want absolutely square, flat, true, and parallel surfaces and edges. The operations, and a picture of a typical completed pair of hinges, are on the webpage that I gave earlier, here: http://www.flysquirrel.net/RogueAir/hinges.html I will sell a set of nine pairs of as-cast, unfinished hinges for $27 plus shipping. In the U.S., I send them out via USPS flat-rate small box, which is currently $6.45. Outside the U.S., I would have to have the rate calculated by the post office but I doubt that it would be more than twice the domestic U.S. rate. Contact me off-list if you are interested, at taildrags@hotmail.com -------- Oscar Zuniga Medford, OR Air Camper NX41CC "Scout" A75 power, 72x36 Culver prop Read this topic online here: http://forums.matronics.com/viewtopic.php?p=469058#469058 ________________________________ Message 2 _____________________________________ Time: 04:20:03 PM PST US Subject: Pietenpol-List: Bolts for torque tube From: "Pocono John" What size bolts did you use to secure the torque tube brackets to the floor? I'm making the flight control pieces now, so any help with the hardware used will sure be appreciated. Thank you! -------- John Read this topic online here: http://forums.matronics.com/viewtopic.php?p=469067#469067 ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message pietenpol-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/Pietenpol-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/pietenpol-list Browse Digests http://www.matronics.com/digest/pietenpol-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.