Today's Message Index:
----------------------
1. 09:38 AM - Re: Upper Brace Wire Fitting (PoconoJohn2)
2. 01:12 PM - Re: !/4" bolt in 5/8" wood? (Clif Dawson)
3. 01:18 PM - Re: !/4" bolt in 5/8" wood? (PoconoJohn2)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Upper Brace Wire Fitting |
Thank you gentlemen. Right now, my plan is to leave the spruce strip in position
per plans and raise the fitting above it (so 1.5" above plans position). The
hinge works out OK above all that keeping with the plans position.
I added a photo to show what is going on. Ignore the beam on top. The pencil is
between two lines. The lines represent the spruce strip. The pencil points at
the plans fitting location. You can see the 1/8" ply for the fitting. To the
left of that, you can see the hole for the eye bolt hinge and it's on the plans
location.
John C
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=496010#496010
Attachments:
http://forums.matronics.com//files/piethinge2_646.jpg
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: !/4" bolt in 5/8" wood? |
1/4" is 4/16. 5/8 is 10/16. The diff is 6/16 or 3/16 on either side of the
bolt.
The photo didn't come through.
Clif
>
> If I'm reading the GN1 plan right (I'm applying this to my Pietenpol), I'm
> supposed to put a 1/4" bolt into a beam which is mostly 5/8" wide (going
> first through the 1" wide edge), so 1/16" margin on either side. Then,
> once the nut is on, I'll have about 1/16" left (7/8" wood + 1/16" washer)
> and I'm not sure if I'll get the minimum one full thread sticking out.
>
> If this is correct, should I reinforce the beam with 1/8" ply where the
> bolt is only 1/16" away (on top and bottom surface in this photo)?
>
> John C
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: !/4" bolt in 5/8" wood? |
Thank you. I saw my mistake right after I posted and deleted the post.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=496024#496024
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|