Today's Message Index:
----------------------
1. 08:42 PM - Plans? (Quinten R Graber)
Message 1
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
--> Pitts-List message posted by: Quinten R Graber <buschray@juno.com>
I'm workin on building an s1s and started building on the ribs. I'm
building them over top of my full scale plans and I got one built and did
some measuring an come ta find out that my spar slots were to far apart.
The plans I built them off of are 1-435 rev F, which says redrawn to
correct rib contour. What is the deal? the plans show that from front
spar to rear spar is 19.5 in. but it measures bout a quarter inch more.
I'm planning on building the aileron ribs from plan 1-438 (S1T) ta use
with my symmetrical ailerons. One other thing I was reading a magazine
article on a Pitts an they said something about an AD on the lower wing
attatch points on the fuselage needing to be made of a thicker metal or
something. Is this something I need to modify on mine bein I am using
some older plans or not?
Quinten Graber
Pitts S1S
The best thing to hit the internet in years - Juno SpeedBand!
Surf the web up to FIVE TIMES FASTER!
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|