---------------------------------------------------------- Rocket-List Digest Archive --- Total Messages Posted Tue 03/02/04: 3 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 06:15 PM - HR II FI elbow (Jim Anglin) 2. 06:15 PM - Re: Cool oil temps cure (Jim Anglin) 3. 07:00 PM - Re: HR II FI elbow (Jones15183@aol.com) ________________________________ Message 1 _____________________________________ Time: 06:15:26 PM PST US From: "Jim Anglin" Subject: Rocket-List: HR II FI elbow --> Rocket-List message posted by: "Jim Anglin" I got the injection fwd looking elbow from Harmon LLC and it is terribly distorted from welding. The corners of the flanges on both ends are warped up + - .040". Anybody know if this will pull down or will it leak air forever? Also, if I install this elbow to the bottom of the sump the studs hit the side of the elbow before it seats. I can cut off the studs or put a spacer between the ell and the sump, which may cause interference problems with the cowl. What are most guys doing? Last - does anyone know if Slick harnesses will fit Bendix mags? Jim in the dark.............. ________________________________ Message 2 _____________________________________ Time: 06:15:26 PM PST US From: "Jim Anglin" "RV List" , "Bruce MacInnes" Subject: Rocket-List: Re: Cool oil temps cure --> Rocket-List message posted by: "Jim Anglin" Thanks Bruce - I have the E2A in my -4 - what size ball valve and where did you get it? To you listers - this should be self ezplanatory. Jim ---- Original Message ----- From: "Bruce MacInnes" Subject: RE: Cool oil temps cure Jim, The cooler baffles don't work. I have a stainless steel ball valve inline to my cooler with a push-pull cable to the panel. It is the only thing that will get the job done on my 0-320 E2D powered RV-4. As I understand it, a fully closed vernatherm still flows some oil, most likely to prevent oil from congealing in the cooler. I try to open my valve (slowly) on every flight to prevent this problem...This system has been in place for many years, is very convenient, and is perfect on long flights (to Florida) when the temperature changes...Feel free to post this to the RV-list. I do not subscribe, but I do like to chec it out...Information on this can be found in the archives. Bruce MacInnes Senior Instructor The Skip Barber Racing School 860-435-4270 W 413-229-8853 H N 14 FT - 463 TT ________________________________ Message 3 _____________________________________ Time: 07:00:13 PM PST US From: Jones15183@aol.com Subject: Re: Rocket-List: HR II FI elbow --> Rocket-List message posted by: Jones15183@aol.com Slick harness will not fit bendix mags. Slick has three screws in rear, bendix has 4 screws in rear. billy