----------------------------------------------------------
                           Rocket-List Digest Archive
                                      ---
                     Total Messages Posted Sun 04/18/04: 2
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 07:36 PM - Re: starter drawing  (Brian Dal Porto)
     2. 07:49 PM - Re: starter drawing  (Archie)
 
 
 
________________________________  Message 1  _____________________________________


Time: 07:36:12 PM PST US
From: "Brian Dal Porto" <bdalporto@sbcglobal.net>
Subject: Re: Rocket-List: starter drawing

--> Rocket-List message posted by: "Brian Dal Porto" <bdalporto@sbcglobal.net>

Archie, I received your drawing, thank you. I going to build the bracket
pretty soon as my starter is giving me problems on occasion. The bendix
sticks. You mentioned welding but I don't see any callout for welds. The
drawing is also missing hole diameters. I can figure them out and I hope
this doesn't sound like I'm nit picking.

Brian Dal Porto

----- Original Message ----- 
From: "Archie" <archie97@earthlink.net>
Subject: Rocket-List: starter drawing


> --> Rocket-List message posted by: "Archie" <archie97@earthlink.net>
>
> To all interested in the starter drawing:
> Tried to send it to Rocket lis, but was rejected due
> to drawing codes.
> Anyone interested can e-mail me direct, and I will send it.
> Archie
>
>






________________________________  Message 2  _____________________________________


Time: 07:49:54 PM PST US
From: "Archie" <archie97@earthlink.net>
Subject: Re: Rocket-List: starter drawing

--> Rocket-List message posted by: "Archie" <archie97@earthlink.net>


> Archie, I received your drawing, thank you. I going to build the bracket
> pretty soon as my starter is giving me problems on occasion. The bendix
> sticks. You mentioned welding but I don't see any callout for welds. The
> drawing is also missing hole diameters. I can figure them out and I hope
> this doesn't sound like I'm nit picking.
>
> Brian Dal Porto

This drawing was made for my use, and in so, had the sizes memorized
and forgot to incorporate them.
Two centerline holes are to accommodate press fit locating pins.
I do not recall the hole sizes, but just go with your original, or I can
check, and e-mail the info.
Archie
Archie's Racing Service