Today's Message Index:
----------------------
1. 12:11 AM - Please Make a Contribution to Support Your Lists... (Matt Dralle)
2. 02:23 PM - gear legs (Kevin Shannon)
3. 05:46 PM - Re: gear legs (Ron Carter)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Please Make a Contribution to Support Your Lists... |
--> Rocket-List message posted by: Matt Dralle <dralle@matronics.com>
Dear Listers,
Just a reminder that November is the Annual List Fund Raiser. Please make a Contribution
today to support the continued operation and upgrade of these great
services!!
The Contribution Site is fast and easy:
http://www.matronics.com/contribution
Thank you!
Matt Dralle
Matronics Email List Administrator
Matt G Dralle | Matronics | PO Box 347 | Livermore | CA | 94551
925-606-1001 V | 925-606-6281 F | dralle@matronics.com Email
http://www.matronics.com/ WWW | Featuring Products For Aircraft
do not archive
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
--> Rocket-List message posted by: "Kevin Shannon" <kshannon@seanet.com>
Gearleg question, this applies to the HR II: a friend of mine asked me if I
had the "newer" style of gear legs, (hard tellin not knowin) So what is the
difference between an old style gear leg and a new style gear leg? Is there
an old style and new style engine mount too? My plans set is dated 1995, I
don't know when the parts were actually purchased. I bought all my parts
second hand.
Kevin Shannon
Starting fuse HRII
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
--> Rocket-List message posted by: "Ron Carter" <ronc@metropolisdesign.com>
There was a gear leg failure back in 2000 where a heavy rocket broke both
legs where the legs exit the motor mount. John immediately added a radius to
the leg to act as a "stress riser" relief. If your legs have any sharp
inside corners on them you probably ought to take them to a machinist and
have the radii turned into them. John Harmon can give you the details.
Ron Carter
Hr2 # 49
----- Original Message -----
From: "Kevin Shannon" <kshannon@seanet.com>
Subject: Rocket-List: gear legs
> --> Rocket-List message posted by: "Kevin Shannon" <kshannon@seanet.com>
>
>
> Gearleg question, this applies to the HR II: a friend of mine asked me if
I
> had the "newer" style of gear legs, (hard tellin not knowin) So what is
the
> difference between an old style gear leg and a new style gear leg? Is
there
> an old style and new style engine mount too? My plans set is dated 1995, I
> don't know when the parts were actually purchased. I bought all my parts
> second hand.
> Kevin Shannon
> Starting fuse HRII
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|