----------------------------------------------------------
                           Rocket-List Digest Archive
                                      ---
                     Total Messages Posted Mon 11/21/05: 3
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 12:11 AM - Please Make a Contribution to Support Your Lists...  (Matt Dralle)
     2. 02:23 PM - gear legs  (Kevin Shannon)
     3. 05:46 PM - Re: gear legs  (Ron Carter)
 
 
 
________________________________  Message 1  _____________________________________


Time: 12:11:55 AM PST US
From: Matt Dralle <dralle@matronics.com>
Subject: Rocket-List: Please Make a Contribution to Support Your Lists...

--> Rocket-List message posted by: Matt Dralle <dralle@matronics.com>


Dear Listers,

Just a reminder that November is the Annual List Fund Raiser.  Please make a Contribution
today to support the continued operation and upgrade of these great
services!! 

The Contribution Site is fast and easy:

        http://www.matronics.com/contribution

Thank you!

Matt Dralle
Matronics Email List Administrator


Matt G Dralle | Matronics | PO Box 347 | Livermore | CA | 94551
925-606-1001 V | 925-606-6281 F | dralle@matronics.com Email
http://www.matronics.com/ WWW | Featuring Products For Aircraft
do not archive






________________________________  Message 2  _____________________________________


Time: 02:23:53 PM PST US
From: "Kevin Shannon" <kshannon@seanet.com>
Subject: Rocket-List: gear legs

--> Rocket-List message posted by: "Kevin Shannon" <kshannon@seanet.com>


Gearleg question, this applies to the HR II: a friend of mine asked me if I
had the "newer" style of gear legs, (hard tellin not knowin) So what is the
difference between an old style gear leg and a new style gear leg? Is there
an old style and new style engine mount too? My plans set is dated 1995, I
don't know when the parts were actually purchased. I bought all my parts
second hand.
Kevin Shannon
Starting fuse HRII






________________________________  Message 3  _____________________________________


Time: 05:46:57 PM PST US
From: "Ron Carter" <ronc@metropolisdesign.com>
Subject: Re: Rocket-List: gear legs

--> Rocket-List message posted by: "Ron Carter" <ronc@metropolisdesign.com>

There was a gear leg failure back in 2000 where a heavy rocket broke both
legs where the legs exit the motor mount. John immediately added a radius to
the leg to act as a "stress riser" relief. If your legs have any sharp
inside corners on them you probably ought to take them to a machinist and
have the radii turned into them. John Harmon can give you the details.

Ron Carter
Hr2 # 49


----- Original Message -----
From: "Kevin Shannon" <kshannon@seanet.com>
Subject: Rocket-List: gear legs


> --> Rocket-List message posted by: "Kevin Shannon" <kshannon@seanet.com>
>
>
> Gearleg question, this applies to the HR II: a friend of mine asked me if
I
> had the "newer" style of gear legs, (hard tellin not knowin) So what is
the
> difference between an old style gear leg and a new style gear leg? Is
there
> an old style and new style engine mount too? My plans set is dated 1995, I
> don't know when the parts were actually purchased. I bought all my parts
> second hand.
> Kevin Shannon
> Starting fuse HRII
>
>