Today's Message Index:
----------------------
1. 10:45 AM - Re: Recomendation on wheel pants, gear leg fairings and intersection fairings (Rob Ray)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Recomendation on wheel pants, gear leg fairings and intersection |
fairings
Jim, I am investigating the use of Kevlar leg fairings and making a new set of
"quick removal" pants. I'll post the results when I install them.
Smokey
Sent from my iPhone
On Aug 30, 2010, at 8:50 PM, Jim Stone <jrstone@insightbb.com> wrote:
>
> Great choice, I am familiar with that set up and was wondering if there is anything
else out there worth considering.
> Jim
> On Aug 30, 2010, at 12:51 PM, Rob Ray wrote:
>
>
> Jim, I challenge my pants and fairings with off road use! I use team rocket leg
fairings over the legs. I wrapped the legs with electricians bundling tape,
no wood. Pants are Vans pressure recovery over 380x150x5 tires. 4 inch height
at rear of tire in level flight attitude . Works well for me, good luck!
> Smokey
>
> Sent from my iPhone
>
> On Aug 30, 2010, at 6:44 AM, Jim Stone <jrstone@insightbb.com> wrote:
>
>>
>> I would like any opinions on the best way to go on the wheel pant and fairing
decision.
>> I'm interested in speed, good looks and ease of installation.
>> Also, is there any reason to put wood on the aft side of the gear legs?
>>
>> TIA,
>> Jim Stone
>>
>>
>>
>>
>
>
>
>
>
>
>
>
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|