Today's Message Index:
----------------------
1. 09:54 AM - Warp Drive Hub (Guy Buchanan)
2. 10:47 AM - Re: Warp Drive Hub (Duncan & Ami McFadyean)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
--> RotaxEngines-List message posted by: Guy Buchanan <bnn@nethere.com>
All,
Donny, one of the locals, suggested that I was over-propped and
that was why my performance was off. (I'm running a 70" Warp 3-blade on my
Rotax 582 with a 3:1 "C" box.) He suggested I go to two blades, or change
the ratio to 3.47:1. Toward that end, I'm looking to see if anyone has a
Warp two blade hub or some 3.47:1 "C" box gears that I might beg/borrow/buy.
Thanks,
Guy Buchanan
K-IV 1200 / 582-C / Warp / 100% done, thanks mostly to Bob Ducar.
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Warp Drive Hub |
--> RotaxEngines-List message posted by: "Duncan & Ami McFadyean" <ami@mcfadyean.freeserve.co.uk>
Not sure what aircraft you're using this on, but by way of comparison I have
seen a 72" 3-blade Warp Drive used with 582 and C-box (3:1) on an Avid
Speedwind. It worked well.
The difference may have been in the backtaper on hte blades, which was
fairly extreme such that the chord length at hte tip was only about 1".
However, Warp Drive themselves set this up. So it might be worthwhile asking
them.
Duncan McF.
----- Original Message -----
From: "Guy Buchanan" <bnn@nethere.com>
Sent: Saturday, October 14, 2006 5:53 PM
Subject: RotaxEngines-List: Warp Drive Hub
> --> RotaxEngines-List message posted by: Guy Buchanan <bnn@nethere.com>
>
> All,
> Donny, one of the locals, suggested that I was over-propped and
> that was why my performance was off. (I'm running a 70" Warp 3-blade on my
> Rotax 582 with a 3:1 "C" box.) He suggested I go to two blades, or change
> the ratio to 3.47:1. Toward that end, I'm looking to see if anyone has a
> Warp two blade hub or some 3.47:1 "C" box gears that I might
> beg/borrow/buy.
>
> Thanks,
>
>
> Guy Buchanan
> K-IV 1200 / 582-C / Warp / 100% done, thanks mostly to Bob Ducar.
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|