Today's Message Index:
----------------------
1. 02:53 AM - Re: 912UL rough at around 4000 (Dave G.)
2. 08:21 AM - Re: 912UL rough at around 4000 (lostpilot28)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: 912UL rough at around 4000 |
Oddly the same thing has happened recently to people on the kitfox list. I
do not have a 912 but I am led to understand that lowering the clip on the
jet needle by one notch ( raising the needle a little) will make the mid
range slightly richer and cure this problem. Again, I have never touched a
912 and am simply passing on what I read. Hope it helps.
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: 912UL rough at around 4000 |
Hey guys,
Thanks...this sounds like what I need to do. How exactly do you adjust the Needle
Jets, though? I'm no carb guru, but I thought the only way to adjust them
was to replace them with shorter/longer jets.
If you CAN adjust them (by a turn of a screwdriver, per se), how do you know what
the new setting is or will do?
Much thanks!
Sonny W.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=73890#73890
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|