---------------------------------------------------------- RotaxEngines-List Digest Archive --- Total Messages Posted Sun 01/21/07: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 04:34 PM - 582 oil injection (369PL) 2. 04:58 PM - Re: 582 oil injection (dave) ________________________________ Message 1 _____________________________________ Time: 04:34:24 PM PST US Subject: RotaxEngines-List: 582 oil injection From: "369PL" I have a kitfox with a 582. The builder of the airplane decided to remove the injection pump and premix 80:1 with NEO synthetic oil. The engine runs fine but I would like to go back to oil injection. Is there any way to calibrate the injection system to 80:1. Or is it best if going back to injection to switch to penziol? Read this topic online here: http://forums.matronics.com/viewtopic.php?p=89378#89378 ________________________________ Message 2 _____________________________________ Time: 04:58:46 PM PST US From: "dave" Subject: Re: RotaxEngines-List: 582 oil injection Nope!! You will get what it is geared for. about 50 to 1 WOT70 to 1 lower settings. No need for 80 to 1 .......... Rotax does not recomend this so why use it ? PS - A note on synthetics in your 582 -- If you use your engine at least weekly you might do ok . If not you will be likely to not have as good of protection from moisture as you would have with mineral oil. that == bearing failures. 582 cranks asre 1200 to 1600 $ new . I use Bombarider XPS Mineral oil and have 123 hours on current plugs in last 6 months and it still running fine. N3 pup? 582 -- should be a rocket on STOL take offs . Movies here http://www.cfisher.com ----- Original Message ----- From: "369PL" Sent: Sunday, January 21, 2007 7:34 PM Subject: RotaxEngines-List: 582 oil injection > > I have a kitfox with a 582. The builder of the airplane decided to remove > the injection pump and premix 80:1 with NEO synthetic oil. The engine runs > fine but I would like to go back to oil injection. Is there any way to > calibrate the injection system to 80:1. Or is it best if going back to > injection to switch to penziol? > > > Read this topic online here: > > http://forums.matronics.com/viewtopic.php?p=89378#89378 > > > ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message rotaxengines-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/RotaxEngines-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/rotaxengines-list Browse Digests http://www.matronics.com/digest/rotaxengines-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.