Today's Message Index:
----------------------
1. 11:15 AM - Re: 914 10mm Banjo to -6 Flare needed (D Wysong)
2. 11:45 AM - Re: Re: 914 10mm Banjo to -6 Flare needed ()
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: 914 10mm Banjo to -6 Flare needed |
Ron,
Here's the web front for Earl's:
www.anplumbing.com
I haven't seen a banjo with -6 ends, though. Mostly -3 and
-4 stuff (for brakes).
Depending on the thread pitch (I *think* the Rotax banjo
bolts are 10 mm x 1.0???) perhaps you can use one of the
straight 10 mm to -6 adapters and attach a 90 degree -6 to it.
D
-------------
>> Anybody know where I could get a 10mm Banjo that ends in a male 37
>> degree
>> flare for a -6 Aeroquip 666 hose fitting? Custom made?
>>
>> Would prefer Stainless, or even steel that is plated.
>>
>> Thx.
>> Ron Parigoris
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: 914 10mm Banjo to -6 Flare needed |
Hello D
"attach a 90 degree -6 to it"
Not enough space for a 90.
I guess I will just have to home grow a 416 stainless banjo. Ground up a
tool for internal radius, works Ok on aluminium, now to get hold of some
416 and give it a try.
Ron P.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|