Today's Message Index:
----------------------
1. 02:38 AM - Re: 914 10mm Banjo to -6 Flare needed (D Wysong)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: 914 10mm Banjo to -6 Flare needed |
Hi Ron,
Must be the fuel supply fitting? I understand now. Getting
the Airbox Pressure sender and a 90 degree -6 fitting to
coexist would certainly be an issue.
One last chance before you roll your own is www.batinc.net
in the MOCAL section. I just tried their site but it was
down (hopefully for maintenance). I *think* their stuff
might be too big, but bookmark the site because they have
what you need when you decide to replacing your oil system
banjos with AN fittings! :-)
Please report back on how your custom fuel banjos turn out.
Machining SS is supposed to be a bear. Good luck with it!
D
------------
> Time: 11:45:56 AM PST US
> Subject: Re: RotaxEngines-List: Re: 914 10mm Banjo to -6 Flare needed
> From: <rparigor@suffolk.lib.ny.us>
>
>
> Hello D
>
> "attach a 90 degree -6 to it"
>
> Not enough space for a 90.
>
> I guess I will just have to home grow a 416 stainless banjo. Ground up a
> tool for internal radius, works Ok on aluminium, now to get hold of some
> 416 and give it a try.
>
> Ron P.
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|