Today's Message Index:
----------------------
1. 12:20 PM - 912uls with vm1000c (flyingmike9)
2. 04:10 PM - Re: 912uls with vm1000c (Roger Lee)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | 912uls with vm1000c |
hello has anybody fitted a vm1000c /vm1000 to the rotax 912uls 100hp
if so how easy/hard was it and do you use the senders from rotax or vm
cheers
mike in uk
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=117848#117848
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: 912uls with vm1000c |
Hi Mike,
Looks like Vision Microsystems supports the Rotax 912uls with its vm1000. Usually
the company that makes the instrument makes the senders and probes. I see it
is a little cheaper than Dynon.
I think your question would be better directed at the Vision Microsystems factory.
I have not seen or heard of one of those units on a Rotax, but that's probably
not saying much.
I read a little about the units online and don't see a reason why it should be
a problem.
As for installation you should have to just mount it in the panel and run all the
wires to the appropriate location. I other words "Some Assembly Required".
--------
Roger Lee
Tucson, Az.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=117907#117907
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|