Today's Message Index:
----------------------
1. 04:29 AM - Backup oil/fuel pressure switch/light (Martin Pohl)
2. 12:14 PM - Re: Backup oil/fuel pressure switch/light (Roger Lee)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Backup oil/fuel pressure switch/light |
I am in search of an additional oil and fuel pressure switch that I will run in
parallel to the Rotax-supplied sensors. The sensors feed the Dynon EMS-120 while
the 2 additional switches shall drive backup warning lights.
They should be normally closed (while at low pressure) and should switch at a pressure
of approx. 0.8bar/12psi (oil) resp. 0.15bar/2psi (fuel).
Does anyone know a source for such switches? Or how did you install your backup-lights?
Cheers Martin
--------
Martin Pohl
Zodiac XL QBK
8645 Jona, Switzerland
www.pohltec.ch/ZodiacXL
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=153791#153791
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Backup oil/fuel pressure switch/light |
Hi Martin,
I have a Flight Design CTSW. I have the Dynon D-100 and the D-120. No additional
back up switches needed. They wire into the D-120 which will give you an alarm
(audible and visual) and I have two dash mounted red warning lights. These
warnings come right from the oil and fuel pressure sensors.
--------
Roger Lee
Tucson, Az.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=153852#153852
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|