Today's Message Index:
----------------------
1. 04:25 AM - Re: Diagnostic tool - AC Power tester (Catz631@aol.com)
2. 09:35 AM - 50VRC Capacitor (George Wells)
3. 10:19 AM - Re: 50VRC Capacitor (dcsfoto)
4. 03:11 PM - Re: 50VRC Capacitor (Roger Lee)
5. 07:02 PM - 582 spark plug wire caps (369PL)
6. 09:37 PM - Re: 582 spark plug wire caps (Roger Lee)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Diagnostic tool - AC Power tester |
Thanks for the tip Roger !
Dick Maddux
Kitfox4
Rotax912 UL
Pensacola,Fl
**************Ideas to please picky eaters. Watch video on AOL Living.
(http://living.aol.com/video/how-to-please-your-picky-eater/rachel-campos-duffy/
2050827?NCID=aolcmp00300000002598)
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Is the 50VRC Capacitor required on the 912ULS installation? I have a
high pitch wine in my radio that I think is either alternator or
ignition noise,will this help ?
Is so where is it placed (wired) in the electrical circuit ?
Thanks
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: 50VRC Capacitor |
check grounds,and install capacitor.
David Kitfox 7
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=166766#166766
Message 4
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: 50VRC Capacitor |
Hi Oscar,
If you do not have a capacitor it will help. It is also recommended to help protect
the system.
--------
Roger Lee
Tucson, Az.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=166819#166819
Message 5
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | 582 spark plug wire caps |
The part #on my caps is TBO5EMA NGK I checked on of them it read 6.2 Ohms. Is
this the proper part #?
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=166859#166859
Message 6
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: 582 spark plug wire caps |
Hi 369PL,
4.5 -5.5 ohms is correct. The standard 5 ohm cap works well. The Rotax 912 uses
the same cap. You can pick up these standard caps at any motorcycle shop. Soft
rubber style or hard plastic, either is ok.
--------
Roger Lee
Tucson, Az.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=166876#166876
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|