----------------------------------------------------------
                           RotaxEngines-List Digest Archive
                                      ---
                     Total Messages Posted Fri 08/21/09: 3
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 02:48 PM - Bing 54  (rayw)
     2. 02:57 PM - Re: Bing 54  (Bob Comperini)
     3. 08:21 PM - Rotax 912 Warning lights  (marcflyer)
 
 
 
________________________________  Message 1  _____________________________________


Time: 02:48:15 PM PST US
Subject: RotaxEngines-List: Bing 54
From: "rayw" <rmwis@charter.net>


Hi all,

I have a 503 DCSI with Bing 54 carbs. Are the jet needles, now, supposed to be
held in place with o rings, clips or both? 

Just a side note. I found one needle bent (with an o ring) and the needle in the
other carb was ok (with a rusty clip).

I Just bought this Kolb and I am finding all kinds of surprises.

Thanks,

Ray W.


Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=259021#259021


________________________________  Message 2  _____________________________________


Time: 02:57:18 PM PST US
From: Bob Comperini <bob@fly-ul.com>
Subject: Re: RotaxEngines-List: Bing 54



On 02:47 PM 8/21/2009, rayw wrote:
>
>I have a 503 DCSI with Bing 54 carbs. Are the jet needles, now, supposed to be
held in place with o rings, clips or both? 

Basically "both". Obviously, the needle is held in place with the circlip. Several
years ago, they added the "O-ring" thing, to prevent the needle from wearing
out. Note: This also included a new design white plastic "cup" (I forget what
its called), that has a little recess in it to accept the O-Ring.


________________________________  Message 3  _____________________________________


Time: 08:21:40 PM PST US
Subject: RotaxEngines-List: Rotax 912 Warning lights
From: "marcflyer" <marcelgina2@hotmail.com>


Has any one tried to install Oil Press and Water Temp warning lights, if so where
does one get the dual sending units in metric. I use VDO guages


Read this topic online here:

http://forums.matronics.com/viewtopic.php?p=259052#259052


 

-------------------------------------------------------------------------------------
                       Other Matronics Email List Services
-------------------------------------------------------------------------------------
Post A New Message               rotaxengines-list@matronics.com
UN/SUBSCRIBE                     http://www.matronics.com/subscription
List FAQ                         http://www.matronics.com/FAQ/RotaxEngines-List.htm
Web Forum Interface To Lists     http://forums.matronics.com
Matronics List Wiki              http://wiki.matronics.com
Full Archive Search Engine       http://www.matronics.com/search
7-Day List Browse                http://www.matronics.com/browse/rotaxengines-list
Browse Digests                   http://www.matronics.com/digest/rotaxengines-list
Browse Other Lists               http://www.matronics.com/browse
Live Online Chat!                http://www.matronics.com/chat
Archive Downloading              http://www.matronics.com/archives
Photo Share                      http://www.matronics.com/photoshare
Other Email Lists                http://www.matronics.com/emaillists
Contributions                    http://www.matronics.com/contribution
-------------------------------------------------------------------------------------

These Email List Services are sponsored solely by Matronics and through the 
generous Contributions of its members.