Today's Message Index:
----------------------
1. 05:06 AM - Re: Low oil Pressure Indication Test Results (dashwood)
2. 08:25 AM - EGT Probe location for a 912ULS? (wildirishtime)
3. 03:39 PM - Re: EGT Probe location for a 912ULS? (Roger Lee)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Low oil Pressure Indication Test Results |
quote "From these results I am satisfied that I do NOT have a low oil pressure
problem in my engine".
and what have we learned...... assemble and analyze all the posts with vdo and
electric oil and the conclusion would be???? get a system that is reliable and
consistent so you can read patterns and react to problems that are real and urgent.
#1 problem with flying and induced pilot errors.... second guessing your
instruments. At 400+ hrs.. what is the condition of the gearbox? have you had
it apart to look at the shims? what is the magnet plug indicating?have you
experimented with other oils on the suggested/ approved list?
--------
Ross Aalexander: CH701 driver 912ul 490tt
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=343974#343974
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | EGT Probe location for a 912ULS? |
One place in the Install manual it shows 3.93" from the head/flange, but it's unclear
HOW EXACTLY you're measuring that (center of the exhaust in a bent tube,
outside of the arc, inside of the arc)? that creates a lot of variation and
potentially a lot of distance.
Then in some other documentation I see it says 2.76" from the head.... something
I found online...
confusion, confusion. Can someone tell me EXACTLY where those darn EGT probes are
supposed to be drilled in and how to measure it for most accurace location?
Thanks!
~Wild
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=343996#343996
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: EGT Probe location for a 912ULS? |
You have it at 3.93. Measure from the center of the tube at the flange and straight
back along the side. Mark it and drill it. If you need to clear something
with the outside probe end then angle it up or down. You'll be good to go.
--------
Roger Lee
Tucson, Az.
Light Sport Repairman - Maintenance Rated
Rotax Repair Center
Home 520-574-1080 TRY HOME FIRST
Cell 520-349-7056
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=344029#344029
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|