Today's Message Index:
----------------------
0. 12:23 AM - Fund Raiser List of Contributors - Please Make A Contribution Today! (Matt Dralle)
1. 06:51 PM - warp drive prop hole. (dashwood)
Message 0
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Fund Raiser List of Contributors - Please Make A Contribution |
Today!
Each year at the end of the List Fund Raiser, I post a message acknowledging everyone
that so generously made a Contribution to support the Lists. Its sort of
my way of publicly thanking everyone that took a minute to show their appreciation
for the Lists.
Won't you take a moment and assure that your name is on that List of Contributors
(LOC)? As a number of members have pointed out over the years, the List seems
at least - if not a whole lot more - valuable as a building/flying/recreating/entertainment
tool as your typical magazine subscription!
Please take minute and assure that your name is on this year's LOC! Show others
that you appreciate the Lists. Making a Contribution to support the Lists is
fast and easy using your Credit card or Paypal on the Secure Web Site:
http://www.matronics.com/contribution
or by dropping a personal check in the mail to:
Matt Dralle / Matronics
581 Jeannie Way
Livermore CA 94550
I would like to thank everyone that has so generously made a Contribution thus
far in this year's List Fund Raiser! Remember that its YOUR support that keeps
these Lists going and improving! Don't forget to include a little comment about
how the Lists have helped you!
Best regards,
Matt Dralle
Matronics Email List Administrator
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | warp drive prop hole. |
i have a 912ul ,t6041 3 blade , 100mm bolt circle prop. purchased by the builder
in 2004. Not sure what the bolt dia is... i am making a prop balancer and was
wondering if anyone knew what the hole size is in this hub. . i just don't want
to take the spinner and prop off more than once if i don't have too. i remove
once and the backing plate is on the outboard side and i couldn't lay eyes
on the hole in the hub.
--------
Ross Aalexander: CH701 driver 912ul 490tt
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=357049#357049
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|