Today's Message Index:
----------------------
1. 03:32 AM - Re: Engine mount bolt torques (MacDonald Doug)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Engine mount bolt torques |
Dashwood, I think you'll find those "J" shaped plates are Zenith parts not
Rotax.=0A-=0ADoug M=0ACH-701=0ANW Ontario, Canada=0A=0ATime: 09:03:45 PM
PST US=0ASubject: RotaxEngines-List: Re: Engine mount bolt torques=0AFrom:
"dashwood" <dashwoodlock@hotmail.com>=0A=0A=0Adoes anyone know where i can
source a parts list for the engine mount (912 tray=0Astyle) not the ring mo
unt... the J shaped parts / angle that mounts to the crank=0Acase- and th
en to the straps under the engine that the rubber mounts go to...=0Ai belie
ve the fasteners talked about above go into the top and bottom of=0Athis pa
rt....=0Ai had a friend watching a shutdown withthe engine covers off and h
e shook his=0Ahead saying there seemed to be to much shaking ....=0Asure en
ought the 10m bolts into the crankcase are have elongated all the holes...
=0Acase seems ok .. all the bolts are lockwired and have not turned but the
engine=0Ais loose on these four bolts... =0Ai need a part # for the left a
nd right side angles and the hardware (bolts ) to=0Amount them...=0A=0A----
----=0ARoss Aalexander: CH701 driver 912ul 589tt=0AIt only takes two things
to fly, airspeed and money=0A=0A=0ARead this topic online here:=0A=0Ahttp:
=================
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|