Today's Message Index:
----------------------
1. 01:38 PM - Re: 582 cutting out at WOT (cristalclear13)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: 582 cutting out at WOT |
ktnc420 wrote:
> My 582 gray runs normal up to about 5700 rpms. When I try to go to full throttle,
it starts cutting out.
> I've replaced all fuel lines and filters and rebuilt the fuel pump. The problem
occurs with the elec. pump on too.
> The carb floats seem to working properly and needles look good.
> Any ideas on what to check next?
> This started happening after somewhat of a hard pull-up to 70 degs. or so, then
leveling off.
> The motor is in pusher config. in a Kolb Mark III.
>
> I'm stumped. SOS
ktnc420, Did you ever find your problem? I found my repair book which takes you
through several things to check. I will type them up here if you still need
help.
--------
Cristal Waters
Kolb Mark II Twinstar Rotax 503 DCSI Sept 2007 - sold Sept 2012
Private Pilot Aug 2008
ELSA Repairman for N193Y April 2008
Rotax 2 stroke maintenance April 2009
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=384583#384583
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|