Today's Message Index:
----------------------
1. 10:49 AM - Re: Re: Refitting the fly wheel (=?iso-8859-1?Q?J=F3hann_J=F3hannsson?=)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Refitting the fly wheel |
Thank you again, Roger, for you help. It was not as extreme as I had thought when
I had the right tool. Flywheel torqued according to the manual.
Best regards,
Johann G.
On 13.2.2014, at 00:39, Roger Lee <ssadiver1@yahoo.com> wrote:
>
> This is about 88 ft/lbs. The one on the PTO side inside the gearbox gets around
149 ft/lbs. It isn't so bad when you compare. 45nm is 398 in/lbs or 33 ft/lbs.
I'm not 100% sure what the extra 180 degree turn would yield, but is common
on head bolts and the like to apply a certain torque followed by a certain amount
of degree turn.
>
> --------
> Roger Lee
> Tucson, Az.
> Light Sport Repairman - Maintenance Rated
> Rotax Repair Center - Heavy Maint. Rated
> Home 520-574-1080 TRY HOME FIRST
> Cell 520-349-7056
>
>
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=418638#418638
>
>
>
>
>
>
>
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|