---------------------------------------------------------- RotaxEngines-List Digest Archive --- Total Messages Posted Thu 03/27/14: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 07:25 PM - Oil Lines and Aluminum AN Fittings (Guy Buchanan) 2. 08:39 PM - Re: Oil Lines and Aluminum AN Fittings (mark donahue) ________________________________ Message 1 _____________________________________ Time: 07:25:34 PM PST US From: Guy Buchanan Subject: RotaxEngines-List: Oil Lines and Aluminum AN Fittings Anybody using aluminum AN fittings on their oil lines on a 912? With an oil cooler? For approximately how many hours? I've been told I must convert to steel for all the oil line end fittings. Tough to do with AN fittings and decent routing. Next: Anybody using AN non-banjo fittings to attach fuel lines to the carbs? I found an 8mm male to -3 AN male steel adapter, but have 1/4" fuel lines so need to convert to -4. I can only find -3 AN to -4 AN converters in aluminum. Guy Buchanan Ramona, CA Kitfox IV-1200 / 912-S / Warp 3cs / 500 hrs. and grounded Now a glider pilot, too. ________________________________ Message 2 _____________________________________ Time: 08:39:57 PM PST US From: "mark donahue" Subject: RE: RotaxEngines-List: Oil Lines and Aluminum AN Fittings Hi Guy, I have alum AN fittings on my LO cooler and have had them for 1000 hrs...no issues. I just have the barbed fittings and fuel hose with clamps to the carbs. Take care, Mark Donahue -----Original Message----- From: owner-rotaxengines-list-server@matronics.com [mailto:owner-rotaxengines-list-server@matronics.com] On Behalf Of Guy Buchanan Sent: Thursday, March 27, 2014 7:25 PM Subject: RotaxEngines-List: Oil Lines and Aluminum AN Fittings --> Anybody using aluminum AN fittings on their oil lines on a 912? With an oil cooler? For approximately how many hours? I've been told I must convert to steel for all the oil line end fittings. Tough to do with AN fittings and decent routing. Next: Anybody using AN non-banjo fittings to attach fuel lines to the carbs? I found an 8mm male to -3 AN male steel adapter, but have 1/4" fuel lines so need to convert to -4. I can only find -3 AN to -4 AN converters in aluminum. Guy Buchanan Ramona, CA Kitfox IV-1200 / 912-S / Warp 3cs / 500 hrs. and grounded Now a glider pilot, too. ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message rotaxengines-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/RotaxEngines-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/rotaxengines-list Browse Digests http://www.matronics.com/digest/rotaxengines-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.