Today's Message Index:
----------------------
1. 04:29 AM - Re: RotaxEngines-List Re: rough running at 3400 RPM and above (MacDonald Doug)
2. 06:03 AM - Re: Re: rough running at 3400 RPM and above (vernon mitchell)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: RotaxEngines-List Re: rough running at 3400 RPM |
and above
Kyle, I'm not sure if I'm the Doug you are referring to or not but I had a
similar issue with my engine when I first started running it on my plane an
d the issue was the chokes were not closed completely.- At higher RPM, sa
y 3400 RPM and higher, the enrichener/choke circuit acts like an airbleed i
nto the intake system which causes a lean stumble (thus why carb heat helps
).- As for the rich indications on the-plugs, I have no idea but first
step is make sure your enricher circuit is absolutely closed after the engi
ne starts.=0A=0ADoug M=0ACH-701/ Rotax 912UL=0A=0A =0A=0A__________________
______________=0A--=0ATime: 10:08:05 AM PST US=0ASubject: RotaxEngines-
List: Re: rough running at 3400 RPM and above=0AFrom: "kyle Ponsford" <wild
_kyle@hotmail.com>=0A=0A=0ADoug,=0AYour descriptions read as if I had writt
en them myself, therefore I was very eager=0Ato read to the bottom and see
your eventual solution, but I found... NOTHING!=0ADid you ever solve your p
roblem? I have not.
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: rough running at 3400 RPM and above |
Kyle.
I might have missed something, but have you had the carbs balanced. I
had all sorts of drama, until the carbs were balanced.
Good luck.
Vernon.
South Africa.
--------------------------------------------------
From: "kyle Ponsford" <wild_kyle@hotmail.com>
Sent: Wednesday, August 20, 2014 1:22 AM
Subject: RotaxEngines-List: Re: rough running at 3400 RPM and above
> <wild_kyle@hotmail.com>
>
> Johann G.,
> I am grateful for your information/suggestion and will tackle that idea
> immediately!
> Thanks,
> - Kyle
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=428799#428799
>
>
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|