Today's Message Index:
----------------------
1. 06:17 AM - Re: Dynon Draining Battery? (Duane Bentley)
2. 07:14 AM - Aero Lift For Sale (Shemp)
3. 05:38 PM - Camloc button latch for oil door (Ralph E. Capen)
4. 07:22 PM - Places to list RV8 kit for sale? (Will Allen)
5. 08:08 PM - Re: Camloc button latch for oil door (Vanremog@aol.com)
6. 08:16 PM - Re: Places to list RV8 kit for sale? (Reginald C. Smith, Sr.)
7. 08:18 PM - Re: Places to list RV8 kit for sale? (Ron Lee)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Dynon Draining Battery? |
Yes, I've had the problem. I purchased one of the early Dynon models,
about 6 years ago. I had it back to the company 2-3 times before first
flight with several developmental issues, but received great support.
During the first year of flight time, I shut down the aircraft normally
one evening and as I was exiting the hangar, I noticed a light from the
canopy and found that the Dynon was running (still). I manually shut it
down, but found that it turned itself back on again. Knowing it would
drain the battery completely, I disconnected it from the buss. After
calling Dynon, they suggested that the keep alive circuit was
malfunctioning. They told me I could send the unit back again for
investigation, or cut the wire from the aircraft power to the backup
internal Dynon battery. I did so, and have never had a problem since.
Duane Bentley
RV6 300 hours
N515DB
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Aero Lift For Sale |
I purchased my aero lift to use in my hangar house that I never built.
It was used as the factory demonstrator at OshKosh for 7 days and has
never been used since. The cost for a new one is $11,500 plus shipping
(easily $1000). Im selling it for 8900. Its good for both nose and
tail wheel a/c. Here's the company website.
http://www.armaerospace.com/. Its in the Chicgoland area.
JFLEISC@aol.com wrote:
> All, I finished sealing my fuel tanks and since there is a 2 week
> waiting time after ordering the sealant I made sure I bought much more
> than I needed so as not to run out during the job. It went much
> smoother than anticipated and I have some left over. I have 2 unopened
> factory sealed pints (one RV-4 tank took me one pint) of PPG P/S 890
> B-2 available with a manufacturing date of 6/08. It states a 9 month
> shelf life. This is the "paste type" and I applied it with a stiff
> brush. It has an application time of 2 hours (I mixed small batches).
> After much research including what I learned from this group I found
> this to be one of the few 'ProSeal' products to specifically list in
> it's tech sheet that it has the same resistance to alcohol as fuel (I
> like the option to run Mogas) (see the link below for the PPG tech
> sheet). I understand that many of the newly formulated sealants are
> alcohol resistant also however those that I read the tech sheets of
> made no specific mention of alcohol. It cost me $55 a pint and I will
> sell to whoever may be interested for $55 for the 2 pints plus
> shipping. If interested email me at jfleisc@aol.com
> <mailto:jfleisc@aol.com>.
>
> Jim
>
> http://buyat.ppg.com/REP_aerospace_files/Sealants/890b.pdf
>
>
> ------------------------------------------------------------------------
> Gas prices getting you down? Search AOL Autos for fuel-efficient used
> cars <http://autos.aol.com/used?ncid=aolaut00050000000007>.
> *
>
>
> *
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Camloc button latch for oil door |
I have the latch - I need instructions....
Do I need to reinforce the area where the latch strikes? How far from the
striker is it mounted.
Any details with specific numbers would be appreciated.
Ralph Capen
Message 4
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Places to list RV8 kit for sale? |
Can anyone guide me to the best place to advertise my tail and wing kit
that
I=92m trying to sell? I=92m not sure if craigslist would hit the right
people.
Will Allen
(425) 785-9922
will@flipsideaerobatics.com
www.flipsideaerobatics.com
Checked by AVG.
10:15 AM
Message 5
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Camloc button latch for oil door |
In a message dated 7/5/2008 5:39:26 P.M. Pacific Daylight Time,
recapen@earthlink.net writes:
I have the latch - I need instructions....
Do I need to reinforce the area where the latch strikes? How far from the
striker is it mounted.
Ralph-
I did rivet a .040" thick sheet U shaped aluminum ledge along three sides of
the cutout in the cowling to both stop the door and give some meat for the
latches (I've got two for redundancy) to bear on. I extended it out into the
opening about .250" on the three edges and it engages nicely and positively.
N1GV (RV-6A, Flying 897hrs, O-360-A1A, C/S, Silicon Valley)
**************Gas prices getting you down? Search AOL Autos for
fuel-efficient used cars. (http://autos.aol.com/used?ncid=aolaut00050000000007)
Message 6
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Places to list RV8 kit for sale? |
Barnstormers is one of the best places to advertise... Folks from all over
the country see the ads. try them: www.barnstormers.com
RC.
RV-6 Wings/Tail
starting fuselage.
From: will@flipsideaerobatics.comTo: rv8-list@matronics.com=3B rv-list@matr
onics.comSubject: RV-List: Places to list RV8 kit for sale?Date: Sat=2C 5 J
ul 2008 19:19:18 -0700
Can anyone guide me to the best place to advertise my tail and wing kit tha
t I=92m trying to sell? I=92m not sure if craigslist would hit the right pe
ople.
Will Allen
(425) 785-9922
will@flipsideaerobatics.com
www.flipsideaerobatics.com
_________________________________________________________________
The i=92m Talkaton. Can 30-days of conversation change the world?
http://www.imtalkathon.com/?source=EML_WLH_Talkathon_ChangeWorld
Message 7
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Places to list RV8 kit for sale? |
Places to list RV8 kit for sale?vansairforce.com
----- Original Message -----
From: Will Allen
To: rv8-list@matronics.com ; rv-list@matronics.com
Sent: Saturday, July 05, 2008 8:19 PM
Subject: RV-List: Places to list RV8 kit for sale?
Can anyone guide me to the best place to advertise my tail and wing
kit that I=92m trying to sell? I=92m not sure if craigslist would hit
the right people.
Will Allen
(425) 785-9922
will@flipsideaerobatics.com
www.flipsideaerobatics.com
Checked by AVG.
10:15 AM
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|