Today's Message Index:
----------------------
0. 12:32 AM - Value of the List... (Matt Dralle)
1. 03:29 AM - RV Christmas Ideas... (K Klewin)
2. 07:26 AM - Re: RV-List Digest: 6 Msgs - 11/22/08 (Frazier, Vincent A)
3. 12:09 PM - Microair 760 Comm (Bill VonDane)
4. 08:47 PM - AFP Fuel Injection (DEAN PSIROPOULOS)
5. 09:06 PM - Antenna Switchbox plans/know-how? (J Riffel)
6. 09:06 PM - Antenna Switchbox plans/know-how? (J Riffel)
7. 09:33 PM - Re: Antenna Switchbox plans/know-how? (Richard E. Tasker)
Message 0
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Value of the List... |
If you look forward to checking your List email everyday (and a lot of you have
written to say that you do!), then you're probably getting at least $20 or $30
worth of Entertainment from the Lists each year. You'd pay twice that for a
subscription to some lame magazine or even just a single dinner out. Isn't the
List worth at least that much to you?
Won't you please take a minute to make your Contribution today and support the
Lists?
Contribution Page:
http://www.matronics.com/contribution
Again, I want to say THANK YOU to everyone that has made a Contribution thus far
during this year's List Fund Raiser!! These Lists are made possible exclusively
through YOUR generosity!!
Thank you for your support!
Matt Dralle
Email List Admin.
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | RV Christmas Ideas... |
Since a few of you have asked.....
-
Here is a link to our christmas specials...
-
http://www.vansairforce.com/community/showthread.php?t=36537
-
Regards,
-
Kurt
www.bisonmountainbags.com=0A=0A=0A
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | RE: RV-List Digest: 6 Msgs - 11/22/08 |
Robin,
I carry a nice product in my store. Cheap too. Also works well on
floorboards. Not gritty and doesn't scuff and hold mud like the
sandpapery types. Easy to wash. Won't tear up your microfiber cloths.
Lots of other RV goodies and supplies too.
Vince Frazier
Flyboy Accessories
3965 Caborn Road
Mount Vernon, IN 47620
812-464-1839
www.flyboyaccessories.com
SNIP<<<<<<<<<<<
Time: 08:37:04 AM PST US
Subject: RV-List: Wing Walk Material
From: "Robin Marks" <robin1@mrmoisture.com>
Dear List,
It's time to think about wing walk material. I could go with the
standard Vans RV-10 material or the (near) clear wing walk material
offered by ACS. Are there any other (good) options available that are
visually appealing and functional or does anyone have a preference on
one material over another?
Thanks,
Robin
RV-4 Sold
RV-6A 465 Hours
RV-10 30 hours
RV-8A Next>>>>>>>>>>>>>SNIP
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Microair 760 Comm |
Hey all...
I am looking for a Microair 760 Comm...
Please contact me off-list...
-Bill
http://www.vondane.com/contact/
Message 4
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | AFP Fuel Injection |
You folks that have Airflow Performance Fuel Injection with purge valve....
What is the easiest way to start the engine? I have been using the official
AFP procedure but you have to juggle the mixture and throttle after the
engine catches (and before it quits again)!! Nothing against Don's
procedure, I just wondered if there might be a way to get a good start with
less monkey motion?! Any thoughts?
Dean Psiropoulos
RV-6A N197DM
First flight yesterday (.5 hours)!!!
Message 5
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Antenna Switchbox plans/know-how? |
I'd like to be able to connect my handheld to my external com1 antenna in an
emergency. I know that the Icom Ant-SB does that - but it's about $75.
Anyone built one (or know how to build one)?
I'm GUESSING that it's just a simple shielded box with 3 BNCs (IN from Com1,
OUT to Antenna and IN from handheld). When the handheld is plugged in, the
BNC from Com1 would be disconnected (so the handheld doesn't xmit INTO
Com1).
Ideas anybody?
Message 6
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Antenna Switchbox plans/know-how? |
I'd like to be able to connect my handheld to my external com1 antenna in an
emergency. I know that the Icom Ant-SB does that - but it's about $75.
Anyone built one (or know how to build one)?
I'm GUESSING that it's just a simple shielded box with 3 BNCs (IN from Com1,
OUT to Antenna and IN from handheld). When the handheld is plugged in, the
BNC from Com1 would be disconnected (so the handheld doesn't xmit INTO
Com1).
Ideas anybody?
Message 7
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Antenna Switchbox plans/know-how? |
The input from the handheld is just a 3.5mm phone plug. When plugged
in, it breaks the internal connection to comm1 and connects the handheld
to the antenna.
Very simple to build, but make sure you get a HIGH quality female phone
plug as you are counting on the internal switched contact to make the
connection for comm1.
Dick Tasker
J Riffel wrote:
> I'd like to be able to connect my handheld to my external com1 antenna
> in an emergency. I know that the Icom Ant-SB does that - but it's
> about $75. Anyone built one (or know how to build one)?
>
> I'm GUESSING that it's just a simple shielded box with 3 BNCs (IN from
> Com1, OUT to Antenna and IN from handheld). When the handheld is
> plugged in, the BNC from Com1 would be disconnected (so the handheld
> doesn't xmit INTO Com1).
>
> Ideas anybody?
--
Please Note:
No trees were destroyed in the sending of this message. We do concede, however,
that a significant number of electrons may have been temporarily inconvenienced.
--
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|