Today's Message Index:
----------------------
1. 09:23 AM - Re: Cable Routing With Front Mounted Governor... (marcausman)
2. 06:16 PM - Rotax 912 for sale (Keithc)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Cable Routing With Front Mounted Governor... |
Matt, very nice and clean!
If I have to replace my existing governor I may just go with your solution.
BTW, those fuel lines are somehwat flexible. If you buy them new they are straight
and you must bend them. So, if needed for clearance, you could loosen the
adel clamp on the pushrod tube and bend the line down a bit.
--------
Marc Ausman
http://www.verticalpower.com
RV-7 IO-390 Flying
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=266950#266950
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Rotax 912 for sale |
I have a Rotax 912 (80hp) for sale. It was purchased for my series 4 project but
the project has been sold and the engine is now available. It has 1490 hrs SMOH.
It came out of a certified A/C(Katana).Very well looked after. I don't recall
receiving logs with it. I was not concerned at the time of purchase as the
logs were not needed for a home built. The compressions were 76/80,76/80,74/80,76/80
at time of removal. $5700.00 cdn. I am located in Cambridge Ontario.
Keith 519-240-3064 keith(at)intev.ca[b][/b]
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=267035#267035
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|