---------------------------------------------------------- RV-List Digest Archive --- Total Messages Posted Mon 08/16/10: 1 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 01:14 AM - Re: positioning right angle AN fittings (StooDDS@aol.com) ________________________________ Message 1 _____________________________________ Time: 01:14:22 AM PST US From: StooDDS@aol.com Subject: Re: RV-List: positioning right angle AN fittings Best way to handle this is to run the male thread of the fitting into the appropriate pipe thread die. These are available at the hardware store. Screw it in by hand until it is tight, then just a little more. Clean the threads and try it. If you use a tap on the female threads, the chips are going to fall into the oil cooler----------- Stewart Willoughby 6,finishing ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message rv-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/RV-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/rv-list Browse Digests http://www.matronics.com/digest/rv-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.