RV-List Digest Archive
Mon 09/05/11 |
Total Messages Posted: 1 |
Today's Message Index:
----------------------
1. 06:46 PM - Exhaust gasket fit. (Brian Huffaker)
Message 1
INDEX Back to Main INDEX NEXT Skip to NEXT Message LIST Reply to LIST Regarding this Message SENDER Reply to SENDER Regarding this Message
Time: 06:46:35 PM PST US
From: Brian Huffaker <bifft@xmission.com>
Subject: Exhaust gasket fit.
Hooking up the exhaust system, using a Vetterman exhaust on a O-360A1D.
The exhast flange seems to fit the engine just fine, but the gasket won't
go on. The slotted holes are just a hair too close together. Tried on
all three of the cylinders that have two studs (one is missing a stud,
didn't notice until I went to put stuff on tonight). The difference is
well under 1/16", is it Ok to file that slotted hole just a hair wider?
Brian Huffaker, DSWL (bifft@xmission.com)
RV-8A 80091 Engine stuff.
1/4 Starduster II N23UT flying
Other Matronics Email List Services
Post A New Message rv-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/RV-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com 7-Day List Browse http://www.matronics.com/browse/rv-list Browse RV-List Digests http://www.matronics.com/digest/rv-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.