Today's Message Index:
----------------------
1. 06:00 PM - After prop overhaul (Bean)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | After prop overhaul |
I may be repeating knowledge already well known but I didn't know.
After getting my prop back from overhaul by Sensenich I couldn't get the front
spinner plate
to align with the spinner. It is attached to the prop dome with 4 capscrews. It
seemed that the
dome had to be rotated slightly. The Sensenich rep said no don't do that. The problem
is that the dome is screwed on and torqued and so doesn't return to the same position
it
was in when you drilled the holes. He says this is a common problem with some Pipers.
The Sensenich solution is to make the holes in the plate into slots. This is what
I did.
Another solution is to just make a new spinner plate. It only means installing
6 nutplates.
cheers Jim
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|