Today's Message Index:
----------------------
1. 05:25 PM - Re: RV-10/14 Aileron pushrod throw (mr.gsun@gmail.com)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: RV-10/14 Aileron pushrod throw |
Unsubscribe, please
Greg
On Thu, Sep 9, 2021, 5:16 AM <recapen@earthlink.net> wrote:
> Folks,
>
>
> I am planning to re-use the RV-10/14 electric aileron trim in a non-10/14
> application.
>
> In order to retain the original motion and torque requirements, I want to
> make sure that I am implementing it in a similar manner.
>
>
> Can someone measure the full pushrod movement of the aileron tubes
?
> Either at the base of the stick, bellcrank, or where you have installed t
he
> aileron trim in your 10/14 Based on the installation instructio
ns, the
> springs are to attach to brackets on the tube 6=9D to either side o
f the
> center point directly above the trim motor. That implies that the motion
> should be less than 6=9D in either direction to ensure spring tensi
on
> throughout the throw range.
>
>
> Thanks,
>
> Ralph Capen
>
> RV6A N822AR @ N06 =9CPatience=9D
>
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|