---------------------------------------------------------- RV10-List Digest Archive --- Total Messages Posted Mon 07/26/04: 1 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 12:53 PM - Re: RV-10 fuselage kit (Randy DeBauw) ________________________________ Message 1 _____________________________________ Time: 12:53:45 PM PST US From: "Randy DeBauw" Subject: Re: RV10-List: RV-10 fuselage kit --> RV10-List message posted by: "Randy DeBauw" Hello Mark and group. We saw the same problem 2 weekends ago. I made the decision to joggle them my self using the plans a to were to make the joggle. When we got done we inserted a 1/4" drill bit into the bolt hole and it fit fine. I told Scott Risen about it last week and he said "we supplied the drawing so you could make the joggle didn't we." Nope. The way I saw it is they are going to send me some new joggled ones or provide the plans for them. Randy ----- Original Message ----- From: "Mark Chamberlain" <10flyer@verizon.net> Subject: RV10-List: RV-10 fuselage kit > --> RV10-List message posted by: "Mark Chamberlain" <10flyer@verizon.net> > > For those of you already pounding through the first few sections of the Fuse kit, I stumbled across another small omition in parts today. I was collecting the parts for Sec 26 when i noticed that the seatbelt attach parts ( fwd and aft seats ) on the plans have a joggle in them while the parts i recieved are all flat. I talked to Vans today and they are looking into it and agree that the attach part should be joggled to allow the belt to be sandwhiched between the bracket and the structure. I thought about bending them myself, however they suggested that the bolt hole might not line up with the other bracket. This all but shoots down the first page or two of Sec 26 until you get the right parts. Vans said they would know more on Monday. I guess i'll start the firewall section and come back to this later . Just a heads up!! Mark > >