Today's Message Index:
----------------------
1. 06:23 PM - Re: Re: Elevator Rig (Chris)
2. 08:24 PM - Trip to Phoenix (Rene)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Elevator Rig |
Thanks for the insight again Bob/Bill, I was able shorten the 1089 and 1090
a bit and get everything to miss everything. For good measure I carefully
rounded the corner of the 1033 control support along its lower outside edge.
My coolie hat on the right stick just misses the bottom of the panel. My
left stick is fine. There seems to be a slight difference in the weldments
between left and right stick, the left stick cleared the 1033 before the
right. With this set up my jig for the stick neutral is about a half of bolt
hole off, I think this is will be ok. Also no interfernce is seen on any of
the control rods and bellcranks going back to the elevators.
Thanks
Chris
#40072
N919AR
W & B coming up!
-----Original Message-----
From: owner-rv10-list-server@matronics.com
[mailto:owner-rv10-list-server@matronics.com] On Behalf Of Bill Watson
Sent: Sunday, September 18, 2011 1:18 AM
Subject: Re: RV10-List: Re: Elevator Rig
Re the stick hitting the panel. Can be dependent on panel choice but
seems like even the standard panel needs to have the stick modified a
bit. I bent mine to reduce it's height. Others have cut and welded to
shorten it and move it back a bit from the panel.
Bill
On 9/18/2011 12:57 AM, Bob Turner wrote:
> --> RV10-List message posted by: "Bob Turner"<bobturner@alum.rpi.edu>
>
> I recall having the same issue; however, mine was fixed by reversing the
direction of the bolts, which you say you have already done.
>
> You certainly do not want them catching, you need to fine tune as needed
to avoid that. Of course, you may have trouble at the other end, too, with
the stick hitting the instrument panel. Depends on what stick grip you use.
I was able (but not with a lot of margin) find a setting that avoided both
problems.
>
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
I might have to fly down to Phoenix this week. Looks like Deer Valley or
Scottsdale are the closest.....Deer Valley looks better from a cost
perspective. Any opinions from the locals or other who have been down
there.
I will be coming from Utah.
Rene'
801-721-6080
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|