---------------------------------------------------------- RV10-List Digest Archive --- Total Messages Posted Sun 09/18/11: 2 ---------------------------------------------------------- Today's Message Index: ---------------------- 1. 06:23 PM - Re: Re: Elevator Rig (Chris) 2. 08:24 PM - Trip to Phoenix (Rene) ________________________________ Message 1 _____________________________________ Time: 06:23:10 PM PST US From: "Chris" Subject: RE: RV10-List: Re: Elevator Rig Thanks for the insight again Bob/Bill, I was able shorten the 1089 and 1090 a bit and get everything to miss everything. For good measure I carefully rounded the corner of the 1033 control support along its lower outside edge. My coolie hat on the right stick just misses the bottom of the panel. My left stick is fine. There seems to be a slight difference in the weldments between left and right stick, the left stick cleared the 1033 before the right. With this set up my jig for the stick neutral is about a half of bolt hole off, I think this is will be ok. Also no interfernce is seen on any of the control rods and bellcranks going back to the elevators. Thanks Chris #40072 N919AR W & B coming up! -----Original Message----- From: owner-rv10-list-server@matronics.com [mailto:owner-rv10-list-server@matronics.com] On Behalf Of Bill Watson Sent: Sunday, September 18, 2011 1:18 AM Subject: Re: RV10-List: Re: Elevator Rig Re the stick hitting the panel. Can be dependent on panel choice but seems like even the standard panel needs to have the stick modified a bit. I bent mine to reduce it's height. Others have cut and welded to shorten it and move it back a bit from the panel. Bill On 9/18/2011 12:57 AM, Bob Turner wrote: > --> RV10-List message posted by: "Bob Turner" > > I recall having the same issue; however, mine was fixed by reversing the direction of the bolts, which you say you have already done. > > You certainly do not want them catching, you need to fine tune as needed to avoid that. Of course, you may have trouble at the other end, too, with the stick hitting the instrument panel. Depends on what stick grip you use. I was able (but not with a lot of margin) find a setting that avoided both problems. > ________________________________ Message 2 _____________________________________ Time: 08:24:55 PM PST US From: "Rene" Subject: RV10-List: Trip to Phoenix I might have to fly down to Phoenix this week. Looks like Deer Valley or Scottsdale are the closest.....Deer Valley looks better from a cost perspective. Any opinions from the locals or other who have been down there. I will be coming from Utah. Rene' 801-721-6080 ------------------------------------------------------------------------------------- Other Matronics Email List Services ------------------------------------------------------------------------------------- Post A New Message rv10-list@matronics.com UN/SUBSCRIBE http://www.matronics.com/subscription List FAQ http://www.matronics.com/FAQ/RV10-List.htm Web Forum Interface To Lists http://forums.matronics.com Matronics List Wiki http://wiki.matronics.com Full Archive Search Engine http://www.matronics.com/search 7-Day List Browse http://www.matronics.com/browse/rv10-list Browse Digests http://www.matronics.com/digest/rv10-list Browse Other Lists http://www.matronics.com/browse Live Online Chat! http://www.matronics.com/chat Archive Downloading http://www.matronics.com/archives Photo Share http://www.matronics.com/photoshare Other Email Lists http://www.matronics.com/emaillists Contributions http://www.matronics.com/contribution ------------------------------------------------------------------------------------- These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.