----------------------------------------------------------
                           RV10-List Digest Archive
                                      ---
                     Total Messages Posted Wed 11/07/12: 2
           ----------------------------------------------------------
 
 
Today's Message Index:
----------------------
 
     1. 07:28 PM - roll servo stop bracket  (Rick Lark)
     2. 08:24 PM - Re: roll servo stop bracket  (davidsoutpost@comcast.net)
 
 
 
________________________________  Message 1  _____________________________________


Time: 07:28:24 PM PST US
Subject: RV10-List: roll servo stop bracket
From: Rick Lark <larkrv10@gmail.com>

Hi all

I installed the roll servo today and found the 2 little 6-32 x 1/4" screws
that fasten the stop bracket woefully short.  I got almost 1 1/2 turns on
them.  Searching the archives revealed a couple of posts but no definitive
conclusion.  Did anyone substitute the screws for something a little bit
longer?  I know using a screw that's too long screw can cause interference
internally.  I'm tempted to remove the lock washer, use a little bit of
lock tite or use both.

Anyone have a better solution?

Thx

Rick
#40956
Southampton, Ont
FWF and Finish kit arrive tomorrow

________________________________  Message 2  _____________________________________


Time: 08:24:28 PM PST US
From: davidsoutpost@comcast.net
Subject: Re: RV10-List: roll servo stop bracket

I did just that: Removed the washer and used Loctite. 


David Clifford 

RV-10 Builder 
Howell, MI 

----- Original Message -----
From: "Rick Lark" <larkrv10@gmail.com> 
Sent: Wednesday, November 7, 2012 10:27:30 PM 
Subject: RV10-List: roll servo stop bracket 


Hi all 

I installed the roll servo today and found the 2 little 6-32 x 1/4" screws that
fasten the stop bracket woefully short. I got almost 1 1/2 turns on them. Searching
the archives revealed a couple of posts but no definitive conclusion. Did
anyone substitute the screws for something a little bit longer? I know using
a screw that's too long screw can cause interference internally. I'm tempted
to remove the lock washer, use a little bit of lock tite or use both. 

Anyone have a better solution? 

Thx 

Rick 
#40956 
Southampton, Ont 
FWF and Finish kit arrive tomorrow 

 

-------------------------------------------------------------------------------------
                       Other Matronics Email List Services
-------------------------------------------------------------------------------------
Post A New Message               rv10-list@matronics.com
UN/SUBSCRIBE                     http://www.matronics.com/subscription
List FAQ                         http://www.matronics.com/FAQ/RV10-List.htm
Web Forum Interface To Lists     http://forums.matronics.com
Matronics List Wiki              http://wiki.matronics.com
Full Archive Search Engine       http://www.matronics.com/search
7-Day List Browse                http://www.matronics.com/browse/rv10-list
Browse Digests                   http://www.matronics.com/digest/rv10-list
Browse Other Lists               http://www.matronics.com/browse
Live Online Chat!                http://www.matronics.com/chat
Archive Downloading              http://www.matronics.com/archives
Photo Share                      http://www.matronics.com/photoshare
Other Email Lists                http://www.matronics.com/emaillists
Contributions                    http://www.matronics.com/contribution
-------------------------------------------------------------------------------------

These Email List Services are sponsored solely by Matronics and through the 
generous Contributions of its members.