Today's Message Index:
----------------------
1. 07:22 AM - Re: Control Column Deflection & Length (bill.peyton)
2. 11:45 AM - Re: Re: Control Column Deflection & Length (Patrick Pulis)
3. 01:13 PM - Another RV-10 down? (Michael Kraus)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Control Column Deflection & Length |
Geoff is correct. I have the Aerosport Panel also. You will end up with the stick
cut down almost the entire amount. You should also cut the lower section
so that it will insert into the control arm further and bring it further back.
After you hook up the controls, you need to make an elevator stop which will
prevent the stick from hitting the front panel on the inside corner. After
that, you can adjust all of the push rods to obtain the correct amount of travel
required by the spec. You need to make sure that the controls have enough
clearance WITH your hands around the grip.
--------
Bill
WA0SYV
Aviation Partners, LLC
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=391703#391703
Attachments:
http://forums.matronics.com//files/img_2596_203.jpg
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Control Column Deflection & Length |
Many thanks Bill & Geoff.
Warm regards
Patrick
On 07/01/2013, at 1:52 AM, "bill.peyton" <peyton.b@sbcglobal.net> wrote:
>
> Geoff is correct. I have the Aerosport Panel also. You will end up with the
stick cut down almost the entire amount. You should also cut the lower section
so that it will insert into the control arm further and bring it further back.
After you hook up the controls, you need to make an elevator stop which will
prevent the stick from hitting the front panel on the inside corner. After
that, you can adjust all of the push rods to obtain the correct amount of travel
required by the spec. You need to make sure that the controls have enough
clearance WITH your hands around the grip.
>
> --------
> Bill
> WA0SYV
> Aviation Partners, LLC
>
>
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=391703#391703
>
>
>
>
> Attachments:
>
> http://forums.matronics.com//files/img_2596_203.jpg
>
>
>
>
>
>
>
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Another RV-10 down? |
http://www.10news.com/news/experimental-aircraft-goes-down-near-julian-pilot
-not-injured-01052013
Do not archive
-Mike Kraus
RV-4 sold :-(
RV-10 flying :-)
KitFox SS7 Radial building :-)
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|