Today's Message Index:
----------------------
1. 09:41 AM - Re: Baggage Tie Downs (johngoodman)
2. 10:56 AM - Re: Enlarging Holes for Conduit in Fuselage (AirMike)
3. 01:48 PM - Test Fit on the Panel (Jeff Carpenter)
4. 06:35 PM - Re: Test Fit on the Panel (Don McDonald)
Message 1
| INDEX | Back to Main INDEX |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Baggage Tie Downs |
I bought the tie downs that Van sells. I like them a lot, but really don't use
them too much. I also bought some baggage netting for Aircraft Spruce. I also
don't use it much.
As far as weight, lead shot costs $3 a pound, while pennies cost $2 a pound. Water
can leak or freeze.
John
--------
#40572 Phase One complete and flying.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=405305#405305
Message 2
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Enlarging Holes for Conduit in Fuselage |
I did enlarge the holes in my aircraft to run the conduit. I was told by one of
the staff at Vans that it would not compromise the integrity of the air frame.
I did do the minimum of enlargement so that I had to really pull the conduit
through. Also, run an extra string through there if you need to pull another
wire through there in the future.
--------
See you OSH '13
Q/B - flying 3 yrs.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=405309#405309
Message 3
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Test Fit on the Panel |
... this is fun
Jeff Carpenter
40304
Message 4
| INDEX | Back to Main INDEX |
| PREVIOUS | Skip to PREVIOUS Message |
| NEXT | Skip to NEXT Message |
| LIST | Reply to LIST Regarding this Message |
| SENDER | Reply to SENDER Regarding this Message |
|
| Subject: | Re: Test Fit on the Panel |
Glad you continued to fight through life's trials and tribulations to keep going
on the 10... Soon you'll be part of the growing family.
Don McDonald
________________________________
From: Jeff Carpenter <jeff@westcottpress.com>
Sent: Thursday, July 25, 2013 3:46 PM
Subject: RV10-List: Test Fit on the Panel
... this is fun
Jeff Carpenter
40304
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|