Today's Message Index:
----------------------
1. 07:54 AM - Holes in rear Center section spar, which bolts? (Mike Whisky)
2. 11:30 AM - Re: Holes in rear Center section spar, which bolts? (Bob Turner)
3. 11:46 AM - Re: Holes in rear Center section spar, which bolts? (Mike Whisky)
4. 07:34 PM - Re: Which quick oil drain for TMX-IO-540 (rv10flyer)
Message 1
INDEX | Back to Main INDEX |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Holes in rear Center section spar, which bolts? |
Hi,
I can't find in the plans which bolts to mount in the two rear holes of the center
section (see picture) a nutplate is attached inside of the center section
on each hole. An AN-4 would fit but I still miss the reason for having a bolt
there.
I didn't find anywhere in the plans what bolts to put in there.
Thanks
Michael
--------
RV-10 builder (final system testing)
#511
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=406410#406410
Attachments:
http://forums.matronics.com//files/img_0054_165.jpg
Message 2
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Holes in rear Center section spar, which bolts? |
Two AN4 bolts, shown in the plans on page 44-11, figure 2.
Help hold the "upright bar".
--------
Bob Turner
RV-10 QB
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=406415#406415
Message 3
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Holes in rear Center section spar, which bolts? |
Thanks Bob, I just realized I didn't look at the revised Plan for 44-11.
Mike
--------
RV-10 builder (final system testing)
#511
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=406416#406416
Message 4
INDEX | Back to Main INDEX |
PREVIOUS | Skip to PREVIOUS Message |
NEXT | Skip to NEXT Message |
LIST | Reply to LIST Regarding this Message |
SENDER | Reply to SENDER Regarding this Message |
|
Subject: | Re: Which quick oil drain for TMX-IO-540 |
I ordered a Saf-Air P5000 from ACS. Works great.
It has a 1/2" NPT, like most Lycomings.
--------
Wayne G.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=406423#406423
Other Matronics Email List Services
These Email List Services are sponsored solely by Matronics and through the generous Contributions of its members.
-- Please support this service by making your Contribution today! --
|